Re: aha152x / SCSI tape problem
[ Forum Home ~ Return to Device Setup Help ~ Post New Message ]
: I have a SCSI QIC150 tape drive on my Adaptec 1520.
: It worked fine under RH303 (1.2.13) but won't buffer writes correctly
: under RH4 (2.0.18).
: I adjust the tape buffers via lilo. (st=1024,1000)
: It seems to stream the reads correctly, but not the writes.
: Can I no longer specify lilo settings for this device since it
: and the controller are loaded by kerneld?
: (My hard disk is EIDE)
: Or is there another way to correctly configure st tape buffers?
If you let load your modules with kerneld you have to put
the options into /etc/conf.modules or /etc/modules.config.
Read /usr/doc/modules how to configure /sbin/kerneld
Post a Followup: